Hardwood Floor Refinishing and Installation in Powder Springs, GA
The Right Fix for the Budget
Not every tired floor needs a full sand. TriArt refinishes hardwood and installs hardwood and LVP across Powder Springs, and we'll quote the least expensive fix that will hold up.
Get help With Your Floors in Powder Springs
Hardwood Floor Refinishing in Powder Springs
Recoat or full sand
A screen and recoat lightly abrades the existing finish and adds one fresh coat. It brings back the sheen but can't reach scratches in the wood or change the color.
It also only works if the new coat bonds to the old one, so we test the finish before recommending it. If a recoat will do the job, that's what we'll quote. If it won't, we sand in three grits to bare wood, sample stain on your floor and finish in three coats. See how to make floors shine again without sanding.
Hardwood and LVP Installation in Powder Springs
Basements, baths and slabs
In a basement on concrete, a bathroom or a utility room, moisture is the risk, and luxury vinyl plank handles it where wood would cup. Above grade, solid hardwood is still the better long-term floor.
LVP is only as good as what's under it, so we check the slab for flatness and moisture first. Where LVP meets hardwood, the transition is planned so both floors sit level. See what LVP flooring is.
Hardwood Floor Repair in Powder Springs
A recoat can’t hide a bad board
A fresh coat over a cracked or stained board makes it stand out more. If the rest of the floor only needs a recoat, we replace the damaged boards first and blend them in. That often keeps the job at recoat cost instead of a full sand.
Hardwood Floor Projects
Photographed on our jobs
What to Expect During Your Floor Project
Before you book
Do we have to leave the house?
Usually not. We work in zones so a bedroom, a bathroom and an exit stay reachable, and most families stay home. Pets need to be out of the work area while finish is going down.
How much dust and smell?
Dust is captured at the sander and vented outside. Edge and hand work still make some, so it isn't dust-free, and we won't say it is. Water-based finishes have little odor; oil-based has more. We'll tell you which we're using and why.
How long until we can use the floor?
Most refinishes take three to five days, plus a day if you're changing the stain color. Furniture goes back 48 to 72 hours after the final coat. Your written schedule shows the dates room by room.
Who moves the furniture?
What’s in the written price?
We measure in your home and leave a written price before we go. Repairs, stain, stairs and removal are listed as separate lines, so you can compare quotes line for line. There's no deposit at the estimate. Once you accept, a 50% deposit orders material and holds your dates.
What if something goes wrong?
Our labor carries a lifetime warranty, in writing on the warranty page. We're insured and a licensed Georgia general contractor (RBCO008240), so a problem under the floor doesn't stop at the flooring.
What Homeowners Say About TriArt
In their words
Questions Roswell Homeowners Ask
Before you call
How much does it cost to refinish hardwood floors in Powder Springs?
A full sand and refinish runs $2.75 to $5.00 per square foot, and a screen and recoat $1.75 to $3.00. You get a written price before we leave.
Should I put LVP or hardwood in my basement?
On a concrete slab below grade, LVP or engineered hardwood. Solid hardwood isn't meant for basements. We check the slab's moisture before recommending either.
Can LVP run right up to my hardwood?
Yes. We plan the transition so both floors sit at the same height, with a threshold that matches the hardwood where one is needed.
Do you charge for the estimate?
No, and there's no deposit at the visit. You can also send photos first for a free opinion.